AeroVironment TurboCord User's Guide download pdf (Page 20)

INSTALLING THE CABLE HANGER

CABLE HANGER MOUNTING INSTRUCTION

1. Choose a location to install the cable hanger.

• The hanger should be located in practical proximity to both the utility

service and the location of your vehicle’s charge receptacle. Preferably

mounted to a wall stud. Dry wall and masonry wall installations require

the use of appropriate inserts.

2. Measure up approximately 36” from the ﬂoor and mark the location.

3. Drill out the preferred mounting holes through the back of the cable hanger

using a

-inch drill bit.

4. Using a Phillips Screwdriver, tighten the screws for the cable hanger.

←

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

AeroVironment TurboCord User's Guide Page 20